200W led Flood light display in our country is developing very rapidly. Now in some areas of the city can see the shadow of 200W led Flood light display. However, if improper operation or to the deep understanding of the 200W led Flood light display may lead to shorten the service life of 200W led Flood light electronic display screen. So what are the factors affected the 200W led Flood light electronic display of life?
Influence factors of life 200W led Flood light electronic display screen, switch 200W led Flood light electronic display screen note:
1 switch order:
When the tail: first boot, then spread its tail.
GuanBing: first, GuanBing after shutdown
(first close the computer's not display, can cause screen body appear high window, burned tubes, the consequences are serious. 2, switch screen time every time more than 5 minutes.
3, computer into engineering control software, and then spread its tail power on.
4, avoid in all white screen state spread its tail, because the system impact current maximum.
5, avoid the tail out of control condition, because the system impact current maximum.
A computer is not in the control software program;
B the computer is not electricity,
C control part of the power supply has been open.
6. The environment temperature is too high or cooling condition is bad, should pay attention to not long tail.
7. Electronic display screen body part in a line of very bright, should pay attention to GuanBing in the state in which shoulds not be long tail.
8. Often display of power supply switch trip, should be timely check screen body or replace the power supply switch.
9. Check it hang strong situation. If have, become loose phenomenon, pay attention to adjust, to reinforce or update the crane parts.
According to the big screen display 200W led Flood light screen body, the control part of the environment, avoid bug bit shall, when necessary, place prevent rat poison. Two factors influence electronic display screen, the control part of the change, change the matters needing attention
1. Computer, control part of the power cord zero, fire can't reverse connection, should be strictly according to the original position plug. If there are peripherals, after the completion of the connection, we should test casing is charged.
2. Mobile computer and control equipment, prior to power should first check the connection line, control panel for loose phenomenon.
3. Don't feel free to change the communication line, flat connection line position, length.
4. Mobile if found short circuit, trip, and burn line, such as smoke appeared abnormal, should not be repeated energization test, should be timely find problems.